Blow Molding Machine Operation Instruction

Blow molding machine operation process
1. Turn the blow molding machine clockwise and the main power switch of the single-screw extruder to turn it from the horizontal state (OFF state) to the vertical state (ON state)

2. Press the green power button on the control panel of the extruder to start the extruder.

3. Press the blue reset button (R) on the control panel of the blow molding machine.

4. Turn the power switch on the control panel of the blow molding machine clockwise to turn it from the off position (o) to the on position (|)

5. Set the temperature of each part of the extruder barrel on the extruder control panel.

6. Set the temperature of each part of the die on the control panel of the blow molding machine.

7. Set the parameters of each step of blowing on the touch screen of the blow molding machine.

8. Add materials to the funnel of the extruder and rotate the funnel to the feeding position.

9. After all parts reach the set temperature, wait for about 15 minutes to ensure that the temperature is stable.

10. Press the green start button on the extruder control panel to start the screw, and turn the screw speed control knob on the extruder control panel to set the screw speed.

11. Press the green start button on the control panel of the blow molding machine to start the motor pump.

12. Turn the mode selection switch on the control panel of the blow molding machine to switch to the fully automatic working mode.

13. After the material flowing from the die reaches the appropriate length, press the green start button on the control panel of the blow molding machine to start the blowing cycle program.

Large blow molding machine equipment

2. Turn off the blow molding machine

1. After the bottle blowing cycle program ends, press the red stop button on the control panel of the blow molding machine to stop the motor pump.

2. Rotate the extruder funnel to the stop position.

3. After the material in the extruder barrel is squeezed out, turn the screw speed control knob on the extruder control panel to set the speed of the extruder screw to zero, and press the red stop button on the extruder control panel. ,Stop the screw.

4.Turn the power switch on the control panel of the blow molding machine counterclockwise to turn it from the open position (|) to the closed position (o)

e (2)
e (1)

Post time: Jul-30-2021