How To Maintain Our Blow Modling Machine

We all know that blow molding machines can be divided into three types of blow molding machines: injection molding, extrusion and special structure. In the plastic manufacturing industry, both injection blow molding machines and extrusion blow molding machines are very important because of their types. Different, so the role played is also different.
The maintenance and repair of blow molding machines are completely two concepts. Although they are all to extend the service life of blow molding machines, maintenance is a routine job in the use of blow molding equipment. Whenever we use blow molding machines , It will be wiped and maintained to a certain extent, whether it is before or after use. It will be inspected according to strict methods, and it will be regularly wiped off dust and oil stains in the work and check whether the lubricating oil is sufficient, and the operating condition of the blow molding machine will also be checked before the formal work. If an abnormality is found, it will be checked immediately, and if a malfunction occurs, it is repaired at this time. Maintenance is for a series of problems caused by machine failures. Through maintenance, the machine can continue to work and produce normally.
1.Be sure to turn on the cooling water in the cooling barrel before the plastic blow molding machine operates to prevent the screw from biting teeth.
2.Preheat the hydraulic oil in the oil tank of the plastic blow molding machine. If the temperature is too low, the heater should be turned on for heating.
3.Check whether the operating direction of the plastic blow molding mechanical pump is correct, and stop immediately if it is not correct.
4.Adjust all the travel switches of the plastic blow molding machine to the correct position, and make the movable template travel far to switch c.
5.According to the safety and complete protection requirements of plastic blow molding machinery, all safety and complete doors will be closed.
6.Switch on the heating and temperature adjustment system of the plastic blow molding machine.
7.Turn on the main switch of the plastic blow molding machinery control cabinet, and set the selector switch to the anti-rust oil in the inching or manual mode.


Post time: Jul-30-2021